When do I need to do this? The XY offset is only responsible for ensuring that the printer places the fiber in the correct position. If the fiber protrudes slightly from its components on some sides...

When is it necessary? The belt tensioners must be replaced if you notice bearing damage or wear. Before you start, replacing the belt tensioners...

Since the update of May 24, 2019, the process for unloading the plastic material has been changed. This helps reduce tangles in the drying box caused by pushing back material.

When do I need to do this? The pulleys need to be replaced if you notice bearing damage or wear. Before you start: There's nothing to do here...

When do I need to do this? Calibration of the stepper motor encoders should always be performed after the printer has been transported. In rare cases, the encoders may...

What do I need to consider? Both filaments are extremely moisture-absorbent. After just 15 minutes of exposure to normal indoor air, an entire spool can become unusable. The filaments...

Under the link you will find useful information and explanations about Eiger Software Eiger Instructions

When do I need to do this? If there's a software-related issue, such as the touchscreen freezing sporadically or USB sticks no longer being recognized, a firmware recovery can help.