{"id":9148,"date":"2020-04-03T15:13:44","date_gmt":"2020-04-03T15:13:44","guid":{"rendered":"https:\/\/www.mark3d.com\/de\/?p=9148"},"modified":"2020-07-21T11:47:55","modified_gmt":"2020-07-21T11:47:55","slug":"wie-entfernt-man-das-stuetzmaterial-bei-markforged-3d-druckern","status":"publish","type":"post","link":"https:\/\/www.mark3d.com\/de\/en\/tipps-zu-technik-und-design\/wie-entfernt-man-das-stuetzmaterial-bei-markforged-3d-druckern\/","title":{"rendered":"How do you remove support material from Markforged 3D printers?"},"content":{"rendered":"

<\/span><\/div>
<\/div>
<\/div>
<\/div>

\u201cHow do you remove support material from Markforged 3D printers?\u201d<\/strong><\/h2><\/div>

That's a good question we get asked a lot. Today we're going to provide some helpful information.<\/p>\n

Basically, Markforged 3D printers always use the same material for the support structure as for the component itself. For plastic printers, this means Onyx, Onyx FR, or Nylon, and for Metal X, the respective metal (tool steel, stainless steel, Inconel, or copper).<\/p>\n<\/div>

And how is this removed after printing?<\/strong><\/h2><\/div>

For plastic parts, the cloud-based slicing software EIGER builds the support structure in zigzag lines beneath the areas with angles below 45\u00b0. This structure is narrow enough to support the area above, but wide enough that it can be removed like an accordion after printing. This leaves a slightly rougher surface on the part, which can be reworked if necessary. We also have a short video on YouTube with the Onyx material:<\/p>\n<\/div>

<\/div>
<\/div>
<\/div>